camaroboy383
Well-Known Member
- Joined
- Feb 25, 2008
- Messages
- 2,833
x637 prop for sure if you have the 1.04:1 gear ratio...from what you explained... the engine is strating to build good temp and wants to burn more fuel.. like stated above,,richen that needle up.... if when you start the engine,,and you hit the throttle for the first time it hits the water,,, and it takes off like a scalded cat at full rpm,, you know right there its to lean...its should be some what un-responsive as far as throttle taking a minute to clean out.. then when the temps increase,,and it wants to burn that needed fuel.. its there for it to lunch on.....take your water cooling completely off if you havnt.... run a hot plug,,i prefer the k&b 1L in the tt..
as far as the prop freeing up in the corners,.,, be sure your transom is square to your ride surface... sounds like pin inclination,,but,, if its stock thats not possible unless the transom is not squared to the ride surface......
alden
as far as the prop freeing up in the corners,.,, be sure your transom is square to your ride surface... sounds like pin inclination,,but,, if its stock thats not possible unless the transom is not squared to the ride surface......
alden