Well,here it is guys.........the final revised prototype of the JAE.21G is done and will be on its way to
North Carolina Monday or Tuesday to Truex B) for final performance testing....
The final revised JAE.21G plans should be ready for release the week of 10-26-2009...
This prototype boat is built plenty stout and its final weight as you see it is 3-lbs 6-oz.I fully expect the Zippkit will be a bit lighter.
As far as I know the kit release date for the Zippkits JAE.21G is still on target for 12-1 2009....
Joe Solinger [www.solingerrc.com] is making motor mounts for the JAE.21G as we speak.
Also JAE and Solinger RC are working on a kit to to convert "any" 1/4-28 SG car crankshaft to a flywheel and flexhex for marine use.
This will be a plug and play flywheel assembly kit that will no require any machining of the flywheel.
The kit will include the flywheel and brass collet to fit the 7MM SG shafts.You will have to buy your own flexhex.
All that will be required is take a cut-off wheel and remove the pilot of an SG shaft and bolt the flywheel up.
This kit will fit any .12,.15,.18,.21 & .28 with a SG shaft. Octura makes a great flexhex for a .130",.150" or .187"
diameter cables with a 3/16" stubshaft.
North Carolina Monday or Tuesday to Truex B) for final performance testing....
The final revised JAE.21G plans should be ready for release the week of 10-26-2009...
This prototype boat is built plenty stout and its final weight as you see it is 3-lbs 6-oz.I fully expect the Zippkit will be a bit lighter.
As far as I know the kit release date for the Zippkits JAE.21G is still on target for 12-1 2009....
Joe Solinger [www.solingerrc.com] is making motor mounts for the JAE.21G as we speak.
Also JAE and Solinger RC are working on a kit to to convert "any" 1/4-28 SG car crankshaft to a flywheel and flexhex for marine use.
This will be a plug and play flywheel assembly kit that will no require any machining of the flywheel.
The kit will include the flywheel and brass collet to fit the 7MM SG shafts.You will have to buy your own flexhex.
All that will be required is take a cut-off wheel and remove the pilot of an SG shaft and bolt the flywheel up.
This kit will fit any .12,.15,.18,.21 & .28 with a SG shaft. Octura makes a great flexhex for a .130",.150" or .187"
diameter cables with a 3/16" stubshaft.
Last edited by a moderator: