Search results

Is any one finding there JAE gas rigger to be bouncing around alot in rough water? and if you are have you found a way to fix it. The boat is running really well in calm water its running in the low 70's with a RZ RCMK with a 3016 ABC prop.

I Have just built a JAE .21 rigger and have fitted a .21 Rossi buggy engine to it that i have had laying for a while and I just was wondering what a good starting point for the pipe length would be. I probably have a bit of a odd combination of parts but its what i had available. I'm using a CMB...

Just wondering if any one can tell me the reason for only sharpening the outside edge of hydro turn fins and not both sides?

I have a CMB RS35 Gas engine I want to make A rigger for and I was thinking of using the JAE .91/1.01 plans and scaling it up, but how big do you think it would need to be? would 50 inch's be long enough with maybe 3 inch's wide sponsons? what are your thoughts.

Hi I have just brought a JAE Gas rigger kit from zippkits and I am a bit confused about what prop to use. In the manual it states a good starting prop is a ABC 2175 but ABC don't even list that prop on there web site, and if you look on the zippkits site they say a ABC 3018 for a RCMK RZ 254 and...

Just wondering if any one has tried to look at the MHZ website lately it doesn't seem to be working for me for some reason.

Hi I've been looking on the JAE site about info on their gas rigger the are developing and I was just wondering if any one know if or when they will be putting the plans up on there sit like the others.

Hi guys, I have had a 40 SD3 Seaducer mono for a while and it runs pretty good but it runs very wet and I can't seem to get it to loosen up. It is running all the seaducer hardware and setup as per the instructions and I'm running a ops 7.5cc motor in it with a x450 prop. Any one got any tips

Hi just wondering if some one could tell me what a starting point is for needle settings on a walbro 257 carby. Its a a 260 mod zenoah.

Hi I have a ops 7.5cc in a seducer mono just wondering if any one has the same and what pipe lenght they are running.

Hi I have a stryker 2 Hydro that I have had for a little while, when I brought it it didnt come with instruction for setup so I searched some fourms for engine placement and strut hight ect and I have my hull up and running now the question I have is, today I finally had the setup instructions...

HI I have had A CMB 1.01 For a little while now and have never been able to get it to run any good it just dosn't seem to want to rev out, I have adjusted my mixtures from 2 turns rite out to 4 and it dosn't make any difference I am running 25% nitro and i have tryed a heap of props. It heats up...

Hi im building a gas fire fighter rigger and puttig a CMB 1.01 into it dose any one have any pic's of a ff that they have put a nitro into. And any mods you may have done?

Hi I know this isnt your typical setup but has any one out there run a nitro engine in any of these hydro hulls? Stryker, insane or seducer.I Have just setup a Stryker 2 hydro with a CMB 1.01 I have got it running fairly well just needs some fine adjustment, just interested to now if any one out...

What would be a good rigger to suit a cmb 1.01, is there any you can buy in kit form to build your self?