LibertyFrancis
Well-Known Member
- Joined
- Jul 9, 2021
- Messages
- 120
Hi all,
Currently I am in the process of building a 2nd wood 33 FE kit to make this a twin rigger. Each side will have a TP4070 and XLX2 esc.
I have utilized a few parts sold by Zippkits for the R6 rigger they will offer at some point (10mm boom tubes, 10mm long boom tube sleeves, and boom tube collars)
You can probably see I am setting up the sponsons further forward to aid in stability for high speed use.
This boat will be exclusively used for GPS speed runs.
For any experienced high speed SAW guys. What are your thoughts about having the 2 main hulls separated by an inch leaving an air gap?
I am looking to mitigate blow-overs as much as possible.
Currently I am in the process of building a 2nd wood 33 FE kit to make this a twin rigger. Each side will have a TP4070 and XLX2 esc.
I have utilized a few parts sold by Zippkits for the R6 rigger they will offer at some point (10mm boom tubes, 10mm long boom tube sleeves, and boom tube collars)
You can probably see I am setting up the sponsons further forward to aid in stability for high speed use.
This boat will be exclusively used for GPS speed runs.
For any experienced high speed SAW guys. What are your thoughts about having the 2 main hulls separated by an inch leaving an air gap?
I am looking to mitigate blow-overs as much as possible.
