Roxyflash

Something wasn’t right should of been able to change adjust strut fin or prop to tame it down.

Terry when you flow the converted pump where do you set the mag gauge when flowing do you use 40 or a different number

Went to river today to test it with Pork Chop Pete first run lost fue l line off carb nipple simple fix used a wire tie on it learned...

Used a fuel bag I know why I quit using them but this was setup with a bag got it filled and burped the air out nice using a starter to...

I remember when tidewater was blowing them out for 175.00 good ole days

Finished it tonite mounted the radio box switch, battery and receiver cut shaft installed drive dog made a strut for the exhaust mount...

I used zipkitts hardware strut rudder trim tabs had a left over turn fin I have a few props.Being hull was a mess didn’t want to put a...

Pork chop gave me a wreaked seaducer 44 both sides on the nose half the side and one strake damage epoxy glass the damage then a little...

Going to make an engine mount for the cmb 27 engine the 4 bolts that engine to mount what size is recommended like 5 mm ?

Here’s my small compressor and gun

I rattle canned the primer use automotive sandable primer I use a paint gun usually after the primer I let the primer dry over nite...

Going to install a cmb 27 in a mono has a tillotson carb need a base line setting on the carb

Mark sent you a message

My bad I thought I read 2716/2 😣

Take the turn fin off set the boat on a perfectly flat surface see how it sets.The turn fin can also make the sponson plow if it’s...