dwilfong
Well-Known Member
- Joined
- Jul 1, 2008
- Messages
- 5,968
Here is the beginning of my OPS 1.27 build up.
This is a OPS .90 eng with a new OPS 1.20 P/L fitted in the case.
Also a VAC .91 rod installed with no modification to the VAC .91 rod or the OPS1.20 piston.
The R/S ratio came in at 1.47 a little lower than I would like. But this will be a grunt eng not a rever.
There needs to be some jocking around to the liner hight and digging in the case to make it all come together.
Looks like the final # will be 135 transfers on the lowest point and any ex I wish.
Thanks again to Steve wood for the great job fitting the P/L to the case.
Thanks Steve.
This is a OPS .90 eng with a new OPS 1.20 P/L fitted in the case.
Also a VAC .91 rod installed with no modification to the VAC .91 rod or the OPS1.20 piston.
The R/S ratio came in at 1.47 a little lower than I would like. But this will be a grunt eng not a rever.
There needs to be some jocking around to the liner hight and digging in the case to make it all come together.
Looks like the final # will be 135 transfers on the lowest point and any ex I wish.
Thanks again to Steve wood for the great job fitting the P/L to the case.
Thanks Steve.