dwilfong
Well-Known Member
- Joined
- Jul 1, 2008
- Messages
- 5,968
After over a year of planing and lot of measuring to see if it would work its all most ready.
Got my VAC 91 case bored by Steve Wood and the small end of the rod honed out .008 after the bushing was removed and it all fit together. installed the RS1.01 P/L and wrist pin and it all worked nice. the transfer ports lined up perfect and the exhaust. Just need to raise the boost port in the case a little.
Just ran the numbers and it is perfect.130 trans and 190 ex.
Now just have to port the case, make a brass button and cooling head.
Steve thanks for the great work. it was all worth it I knew it would work.
David
Got my VAC 91 case bored by Steve Wood and the small end of the rod honed out .008 after the bushing was removed and it all fit together. installed the RS1.01 P/L and wrist pin and it all worked nice. the transfer ports lined up perfect and the exhaust. Just need to raise the boost port in the case a little.
Just ran the numbers and it is perfect.130 trans and 190 ex.
Now just have to port the case, make a brass button and cooling head.
Steve thanks for the great work. it was all worth it I knew it would work.
David