RS EVO P/L RETRO FIT

[Ian Folkson]

In fact all the tests at CMB were done in a RS case but the production EVO case even surprised Mauro as to how much better the EVO was Revs were the same as before but prop size 1 or 2 mm larger diameter.

 

[dwilfong]

From what I see with this retro fit the case needs to be opened up in the transfer ports. The ports in the liner are wider than the casting in the RS case.

If you do your own case work the final out come will be the same no mater what case you use.

Those that will try this it will not be just a liner swap for sure.

Just a way to up date the old engs with out dropping $700 large to the door on a new eng.

$250 P/L and boar job is a lot cheaper than a new eng. once the case is board just drop in a new P/L.

To bad thy did not go just a little bigger on the OD to save all those old EVO engs from the scrap heap.