Jan Kinley
Member
- Joined
- Jan 8, 2009
- Messages
- 17
Hi guys. Just finished a bunch of straight fins for the UL-1.
Was wondering if there would be any interest in blank fins that are not drilled for use on other boats before I tear this setup down?
The fins are made from 7075(very strong) aluminum at .090 thick.
Also what angles would you like to see on this fin? 5% 10%? Where would you like to see the angle start, top, middle, bottom?
Any input appreciated.
Was wondering if there would be any interest in blank fins that are not drilled for use on other boats before I tear this setup down?
The fins are made from 7075(very strong) aluminum at .090 thick.
Also what angles would you like to see on this fin? 5% 10%? Where would you like to see the angle start, top, middle, bottom?
Any input appreciated.