Propjockey
Well-Known Member
- Joined
- Sep 16, 2002
- Messages
- 2,105
Howdy from Texas...I've been asking these questions on several boards, trying to get some input as to what direction to go.
I'm finishing up a small outrigger (24"), and was wondering what would happen if I put a strake down the center of each sponson to break up surface tension.
What about two strakes, one on each edge of the sponson to create a small tunnel?
I've gotten some ideas and opinions, but few people seem to have any experience with this (possibly because it's a lame idea?)
If you frequent the other boards, and are tired of seeing this question, I apologize--I'm just trying to get some input before I start mixing epoxy.
Thanks in advance.
I'm finishing up a small outrigger (24"), and was wondering what would happen if I put a strake down the center of each sponson to break up surface tension.
What about two strakes, one on each edge of the sponson to create a small tunnel?
I've gotten some ideas and opinions, but few people seem to have any experience with this (possibly because it's a lame idea?)
If you frequent the other boards, and are tired of seeing this question, I apologize--I'm just trying to get some input before I start mixing epoxy.
Thanks in advance.