Does anyone know of someone modifying an OS 3/16 shaft to a 1/8" shaft or making an OS prop assembly with a 1/8" shaft diameter to accommodate smaller X series octura props on a Lawless 3.5 lower unit? Any Help would be appreciated. G Ray Hamby
prop shaft assembly
- Thread starter graydds
- Start date
Help Support Intlwaters:
HOTWATER
Well-Known Member
- Joined
- Jan 14, 2008
- Messages
- 1,820
You can always buy one of these lowers with 1/8" shaft...If you want to go electric...
---> http://www.offshoreelectrics.com/proddetail.php?prod=ose-80980
-Kent
---> http://www.offshoreelectrics.com/proddetail.php?prod=ose-80980
-Kent
Last edited by a moderator:
Kris Flynn
Well-Known Member
- Joined
- Mar 11, 2002
- Messages
- 4,344
nice lower unit there Ray
I will see how hard it is to turn them for you...but then it will need to be threaded M3 again...a fiddly job!
I will see how hard it is to turn them for you...but then it will need to be threaded M3 again...a fiddly job!
Kris--Don't go to much trouble--My backup plan is to go with the OS mini OB when they are back in stock for a 3S setup on the Baby Bullet. If I use your great lower unit mod with a 3s lipo and a seaking 120a v3 esc that I have what motor, battery mah would you suggest? Smallest X prop with 3/16 shaft is an X437 which could be cut down to 32 to 34 mm dia. Are there any other small props that might work? Wish I knew more about FE setups. How's the M11 Dragon? Ray
