noise in the antennae wire

[anthony_marquart]

My servoes have some shudder,.. when I touch the antennae or wiggle the wire they shake alot..

cause? fix?

 

[P THOMAS]

Sounds like you need new reciever what radio system is it.

 

[anthony_marquart]

JR,.. the one where you dial in the frequency.

I was thinking maybe a bad antennae connection.

 

[Nigtmare]

My servoes have some shudder,.. when I touch the antennae or wiggle the wire they shake alot..

cause? fix?

does the pipe an header touch each other? if yes pull them apart a bit, or maybe you battery's are low.

 

[Ronald Van Wagnen]

Generally this is seen when the transmitter and reciever are too close together in a confined space. Move 6' away from the boat and the problem will subside.

It is worse when all batteries are fully charged.

 

[moparbarn]

try what ronald said, anthony . i have the same issue with ANY (3 tx's & 11 rx's) of my jr xs3 transmitters & either rs300 or 310 rx's. if it won't subside, you have a bad tx or rx. that's one thing i like about jr equipment, i can shut the tx off if my boat dies or flips, servos lay dead quiet, unlike some futaba's can do.

 

[jon harter]

when you get too close or touch the antenna wire your rx picks up your body hum. just move away.