KRE 90 Engines

[Terry Keeley]

I've had some O'Donnell plugs stuck in L.A. for two weeks, mail is awful right now.

I've also had a new DRO for my lathe in a DHL warehouse here for four weeks waiting for customs clearance...

 

[john bass]

good morning.... tested yesterday and found the brass drum rotor bushing turned a little and cut off about a third of the port area ....have you had that problem before ????.....also the engine is still tight at bottom dead center

 

[Wasted wages]

That's not good...

 

[Butch Londrigan]

My bloody ripper came today.

 

[Ken Retallick]

That isnt good John. Cant say ive had that happen before.
PM sent.

 

[Butch Londrigan]

Any one no what collet these take.

 

[ALLAN YUEN]

Any one no what collet these take.

8mm collet .250 drive or square drive as same as CMB 67/80 or CMB 91/101

 

[Butch Londrigan]

Tried cmb collet and won't thred on.

 

[john bass]

thanks for all your help....you stand behind your product 100 percent...

 

[ALLAN YUEN]

Tried cmb collet and won't thred on.

Which one who make? Areomarine ,Speedmaster or A/A Hobbs ?

 

[BobLondress]

Mark Bullard and I got mine installed in my SST 90 boat. It had a NR 91 in it before. No surgery, just changed spacers on the mounts and a new pushrod for the carb. Last weekend we ran a few tanks of fuel through it on the table. Motor sounds very nice, taking to the lake next weekend.

 

[Andy Nightingale]

Staffan,

I am working on a .45 Not planning on .21 engine.

Ricky Neal is working on a .21 which i am keen to try!

Any updates on this?