Here is what I have found..
The location is not super critical.. its like a flow meter.. its relieve to your setup.
What is nice about this is... you can see at what temp the engine is at when your pipe comes on.
Grim.
neve thought of it that way Mike thanks !
see ya this summer ??
Not my best video BUT... I hope you are able to take something away from this.. enjoy..
Grim
Hi Mike, I have a 7px now too and have a temp sensor on the center dial it will show current temp at bottom in F but highest temp in the center appears to read in Celsius.
Is this a setting to be changed or a system glitch?
Thanks Mike
Good stuff.
The only thing I’d add is to try to use the shortest servo arm possible, it spreads gear wear over more teeth as well as optimizing servo resolution.
John
I have that receiver in every boat I own and I have had ZERO failures.Hello Grimracer,
Where is the best place to purchase a couple of Futaba R203GF receivers? I was looking at the compatibility chart and of these are there any cheaper alternatives that would be as good as the R203GF receiver?
Thanks for your time,
Lee
Does it have GPS in recieversComing soon..... hope to get a video out this week on the 3PV
Enter your email address to join: