Hi Guys!
I've used Savograin "Super Strip" on several epoxyglass hulls. This stuff is a pretty nasty stripper.....You just can't walk away from it. 2 or 3 minutes is the max. time to leave it on. this should at least soften the old paint so you can scrape a layer or two off with a dull putty knife.Do small areas, watch it wrinkle, scrape it off, and wipe up the drips with acetone. Use medium steel wool dipped in stripper to get the last little bits off. again, not too long in one spot. Use masking tape on the edges of the hatch area. try not to get any in the interior of the hull. If the hull has nicks or cracks, maybe fix them before you strip. you don't want to get stripper imbedded in the cracks. Make sure whatever stripper you use is water rinseable.
Don is right about chemical residue. I wash the stripped hull with acetone and then scrub it with warm soapy water( dish soap) and a brush.
only problem I ever had using this method is a time I stepped away to get the phone and let it on too long.
Take your time, be careful, Good luck!!
Bob the Fool :blink: