1/8th to Square coupler

[MOTOboat]

Hi Folks,

Building a small FE tunnel for my son. I would like to use a K&B lower and a Lehner XL. I need a 1/8 shaft to square shaft coupler. I have a few 5mm to square couplers. I may be able to use a brass insert to make up the difference, but was wondering if folks were aware of any that would work for this application.

I have an old Dolphin lower that would work(as I have the coupler)..but once the shaft goes I'll have no parts. Trying to use the extra stuff I have.

THX

Dave

 

[Kris Flynn]

I am sure Richard Konnen could drill a 3.175mm hole in his couplers instead of a 5mm so get onto him i think he is RKonnen or something like that on Rum Runner

Kris

 

[MOTOboat]

THx Kris