Search results

thank you Gale54, Jone's crew thinking full scale but building eighth scale explains how the bottom of this boat came to be. thats way cool. answers alot of questions. where did the one you have end up and was it ever ran? mine has had fuel in it and appears to have run the motor , but shows...

didn't know this boat was topic . put it on craigslist but it found its way to inter/waters. any way its 17 lbs dry with the cowl and weighed the cowl by itself as it is heavy and it came in over 1 1/2 pounds . its offset with the strut offset to the other side. will try to get pictures to...

when i installed the engine in the houston in picture in last post by dasboatman, look closely and you will see that the motor is also turned to the left to get the weight even more to the left front. the flex shaft tube has an extra bend in it. worked great. still working. a 2 cycle...

if you advertize whats in the trailer it will surly draw the attention you want as you drive down the rode,but when you stop for the night it all changes, my harley trailer and porsche tralier and rc nitro boat trailer don't say anything on them execpt good sam club , only because they sent me...

Randy, went to monroe with unw, good meet also, wanted to go to marysville sunday but to many home projects. we have a joint race coming up. see you then. gene

please post your results. " they say " one pound of racipacating mass is equal to 7 pounds of dead mass. I think a heavy boat in rough water would benefit with a heavy flywheel or spinning mass. smooth water maby not.

your working with an 1 cyl motor. 360 degrees with only one bang and two or three blades in the soup , and your going to lighten the flywheel? not me.

mine is a mokey wards with the big flat leather belt 3 speed drive. bought it 35 years ago and it was a antique then. Mike Cathey (unw) had his mitts on it today and he as well as me came to the cunclussion that it is capable of doing more than we know how to make it do it. have seen mine with...

it just a mahogany board cut , screwed, sanded, varnished, cheap and easy. keep it strong and light.

these are the boat stands we buy from our local wigwam stores. hope the picture is attached

Mikey, the MISS BURIEN was rebuilt along with the Pak and Houston and all three are ready for battle. hope to see you this year. Fred U60 here are the pictures you requested. thanks, gene

pm sent , thanks David, gene

Thanks 860, as far as a trade, I am looking for a 25 or 30 hp outboard with a jet unit for a boat project i'm playing with.

Lohring, don't get too old , we still need you at silver lake for testing. happy birthday. gene

check out the "for sale" fourm on this site if your looking for a 1/8 scale nitro boat.

[attachm ent=11733:por_69pak_009.jpg] this is built with the motor as far forward as can fit , clearing the cowl, and shoved it over to port to hold sponson down. ran good what little I got to run it and nailed a 1" stainless ladder attached to a floating trampoline. is it just me or do...

[attachm ent=11730:por_69pak_029.jpg] hope pictures go thur when I hit post .

[attachm ent=11725:por_69pak_038.jpg] This is an old boat remod, taken out tested , changed, tested, again and again till got it working quite well. then disassembled and complete cosmetic redo. has: low mi 67 green (with new bearings) OS9 b carb, sombodys header with a polished Muck pipe and...

Bill , think your right, servo life wasn't a problem, but bet if I had a amp meter on it hard over probably would peak out. thanks