Search results

Or anyone else that stocks these. I ate a bouy and the bouy ate my pipe. I need one to setup before the Internats. CMB .45 RS in a Seaducer.

I just got a new Seaducer with a .45 CMB RS. set up. 450/3 prop - Hitec HS645MG steering servo. When at speed I try to turn, the boat just cranks into a tight turn and will not straighten until I let off some throttle. When I do let off the boat quicklt cranks the other way because I'm not quick...

HTB 290 with CMB LS and Lawless with Strongarm shafts. I grease the shafts with Mercury outboard grease after every heat and I only get about two heats before the shaft looks like it is starting to spin near the prop end. Is there something else I should be doing beside buying caselots of these...

Does anyone have a phone no. for Jerry Crowther or a supplier for a new SD3 .45 Mono? Wanna try to get one wet soon.

Shouldn't March's Roostertail be avail. yet? Lookin' to set up summer schedule and need flyers. Got the itch!!!

I know the races will be starting in May, but I haven't found any flyers yet. Anyone out there in Dist. 12 know of any or who to contact? I'm in Dist. 1 and the water will probably be hard when you're racing in Dist. 12. <_<

There used to be a great invitational race in Hagerstown, MA. in early May. I have been out of it for a bunch of years but I really enjoyed this race. Are there clubs in that area planning a race around then? I think I'll be hooked up by then and maybe ready.

Going to use third channel needles on my boats. My question is where to mount them. Should they be up near the carb on an outboard or can they be mounted lower, next to fuel tank. Where does everyone put these? On my cat mounting will easily be near carb. I set up my Jr XS-3 radio buttons for...

Anyone using one of these new radios yet? I just got one and will try programming this weekend. Looks like it may be fun. A lot of features for cars. I'll have to wait for spring though to tune it fully. Water is starting to harden here. :(

I have a nice Aeromarine cat w/ .67 OPS. Redoing radio box, stuffing tube, floatation, etc. Would like setup for CG and any other tricks. This was a very fast boat, of course, I want more!!!!! ;)

I am leaning toward a new Hopper 290. I have a mod. CMB LS w/ Lawless. Does this boat run good out of the box or are there some mods. needed to make it go fast. Not real good at woodworking or filling and sanding. Want to go fast though. ;D

Hi folks! I am starting my rc boating adventure again after about ten years. Kids in sports are the main reason for my departure before. Now beginning with the empty nest thing. Always been interested in outboards. Had a couple of K&B's on early Dumas boats before. I have a couple of hulls that...