J
javier molina
Guest
Nice you where making good power. 101 motors are not suppose to RPM from what I hear
Ya it dose have some comparisons. :lol:Your Graph looks more like the water we were racing in?????????
Thy will rev just don't live there for long.Nice you where making good power. 101 motors are not suppose to RPM from what I hear
Great news but the cranks are still with Steve.David,
Did the jet ski impeller arrive yet?
Check your mailbox tomorrow.
I received some electronic mail today.
Thanks,
Mark Sholund
Did you get the pipe ?
David,Great news but the cranks are still with Steve.David,
Did the jet ski impeller arrive yet?
Check your mailbox tomorrow.
I received some electronic mail today.
Thanks,
Mark Sholund
Also got a new a 1/8" aluminum transom to install.
Then need some break in time before the impeller.
Hope its got some pitch to keep this beast from over reving.
27600 is a bit to much for it to live.
Wonder why it pulled the piston off the pin.NEXT!
Is that new 1 1/4" rudder in the box?
David
AlbertDavid,Great news but the cranks are still with Steve.David,
Did the jet ski impeller arrive yet?
Check your mailbox tomorrow.
I received some electronic mail today.
Thanks,
Mark Sholund
Also got a new a 1/8" aluminum transom to install.
Then need some break in time before the impeller.
Hope its got some pitch to keep this beast from over reving.
27600 is a bit to much for it to live.
Wonder why it pulled the piston off the pin.NEXT!
Is that new 1 1/4" rudder in the box?
David
My friend elias has an Eagle with a transom that was comming off. I made a small box out of carbon and glass that had the same dim as the inside of the transome. The box had sides that were 3/4" high. In order to make this and get it strong and light, I made a male and female mold with wood. I layed the clothe over the male plug, used some Seran Wrap to keep it from sticking and pressed it all together. When finished and trimmed we glued the box onto the transome. What you end up wioth is a carbon glass transome plate that has a 3/4" lip all the way areound. Once set there is no way to loose the transome ever again unless you pull the whole back end off including sides, bottom and top of the boat. It is very light weight and strong as can be. Think of a carbon glass box the attackes the rear transome to all four sides. This blows away any metal plate.
Albert
thanks for the heads up. Dumb a$$ would not have even thought about it.David, keep the rug fiber away from the prop. lol Good luck with your 100mph goal. Richard D
This ain't no shelf queen. Brutus likes that stand it give him character.David , that stand is ghetto !!!!! Polish that aluminum also !!!!![]()
I didn't build the sponsons !! Lots of epoxy in there too ! You know I'm just breakin stones !!This ain't no shelf queen. Brutus likes that stand it give him character.David , that stand is ghetto !!!!! Polish that aluminum also !!!!![]()
Hell at least he doesn't have wood screws thew the top of the sponsons to hold the boom tubes in.![]()
Enter your email address to join: