Tunnel design in CAD

[anthony727]

Just figured I would share some pics of a tunnel design I am working on in CAD. Check out the likns below. I still have to make the mdels for the sponson skins, the center section nose pieces, the motor, the electronics, and the cowl.

jm-30001-06_01

jm-30001-06_02

jm-30001-06_03

jm-30001-06_04

jm-30001-06_05

jm-30001-06_06

-TS

*************************************************

Website: http://www.jmarsol.com/slecka/

Email: [email protected]

*************************************************

 

[tracerbob]

What software do you use?

 

[anthony727]

Using Pro/Engineer Wildfire 2.0

-TS

*************************************************

Website: http://www.jmarsol.com/slecka/

Email: [email protected]

*************************************************

 

[ZIonOB75]

lokks great, what's the specification?..is this a scale or have ur own design?

 

[anthony727]

lokks great, what's the specification?..is this a scale or have ur own design?

Basically what I did was start with a combination of my TS2 and a Hot Shot Sprint 3.5 and molded a base hull and added a lot of my own touches. I ran it thorugh some aerodynamic software, which was basically a virtual wind tunnel, to work out some of the air pockets and other bad areas, I can post some images of that if you'd like. I am still working on a model of the outboard motor, servos, batteries, fuel, and radio receiver to properly calculate the CG. Right now without that stuff I have gotten the CG right on the edge of the radio box in the center of the deck cross-section.

-TS

*************************************************

Website: http://www.jmarsol.com/slecka/

Email: [email protected]

*************************************************