servo twitching

[k&b guy]

am building a ts2. airtronics receiver & th. servo. steering servo is t. hobbies hi torque # ts64. st. servo hums, causing th. servo to twitch. disc. st. servo, th. servo quits twitching. t. hobb. said hi torque servoes do this sometimes. tried other new one away from th. servo, same thing. th.& steering work o.k., just acts up sitting still. help me out fellas. CARTER

 

[rcpilotbill]

Some servos are electrically noisy, specially under a load. If you are using a pull-pull type of steering setup, you can sometimes have the setup too tight which will try to pull the servo off of center (causing the humming of the servo)..... this whole thing does not inhibit the actual working of either servo, but they can twitch.....

Other than that, there is the possibility that the mg steering servo is feeding back the electrical noise on the servo wires in to the receiver and affecting other servos connected to the receiver

Not sure if that is the situation you have, but just one that I have seen.

Bill

 

[Grimracer]

Alot of times a HP servo like the one you have is looking for center.. it does it so fast the servo can buzz or chatter.. Nothing wrong..

let her rip

Grim

 

[k&b guy]

will do, grim. thanks guys. CARTER