Foolwitools
Well-Known Member
- Joined
- Apr 15, 2003
- Messages
- 768
Hi Guys,
Prather 40" outboard Vee with a K&B 7.5 Pro...........
Never had an outboard Vee before. got no idea how to trim it out
assembled as per prather instructions with Prather's outboard hardware...... CG where it should be............
will not turn above 1/2 throttle. doesn't hook or spin, just rolls onto it's side.
also rolls over easily at full power in a straight.
prop depth is just below keel as per instructions. got a little up angle in the motor.
The only thing I did outside the instructions was to put in a larger turn fin. the one supplied in the kit was soo small, it didn't seem that it would do anything.
Could the larger fin be the whole problem??
Thanks for your help and ideas,
Bob the Fool :blink:
Prather 40" outboard Vee with a K&B 7.5 Pro...........
Never had an outboard Vee before. got no idea how to trim it out
assembled as per prather instructions with Prather's outboard hardware...... CG where it should be............
will not turn above 1/2 throttle. doesn't hook or spin, just rolls onto it's side.
also rolls over easily at full power in a straight.
prop depth is just below keel as per instructions. got a little up angle in the motor.
The only thing I did outside the instructions was to put in a larger turn fin. the one supplied in the kit was soo small, it didn't seem that it would do anything.
Could the larger fin be the whole problem??
Thanks for your help and ideas,
Bob the Fool :blink: