- Joined
- Apr 14, 2008
- Messages
- 2,016
Selling my Rigger with CMB 101RS
Selling as is. The engine is disassembled. The boat could use a fresh finish but is otherwise in very good condition. It has never been wrecked or repaired. There are aluminum servo trays ready to accept servo's so radio gear will be direct bolt in. Canopy needs mounting still. There is a one inch long crack in the canopy on one side where the rear mount tabs would hold it down.
The engine is in great shape and has 3 gallons through it. There is a new set of high end phenolic bearings there for it along with many spare parts. There is extra remote mixture needle valve. There are several low speed carb needles, wrist pin clips, head shims and water cap orings.
There is a AB billet header and pipe that runs awesome on the 101.
$850 shipped in the U.S. ONLY. SOLD
Selling as is. The engine is disassembled. The boat could use a fresh finish but is otherwise in very good condition. It has never been wrecked or repaired. There are aluminum servo trays ready to accept servo's so radio gear will be direct bolt in. Canopy needs mounting still. There is a one inch long crack in the canopy on one side where the rear mount tabs would hold it down.
The engine is in great shape and has 3 gallons through it. There is a new set of high end phenolic bearings there for it along with many spare parts. There is extra remote mixture needle valve. There are several low speed carb needles, wrist pin clips, head shims and water cap orings.
There is a AB billet header and pipe that runs awesome on the 101.
$850 shipped in the U.S. ONLY. SOLD
Last edited by a moderator:
