.12 headers & Pipes

[Dan Chase]

Who makes headers and pipes for .12 & .15 motors? I figure I can use car headers, but if there is a better source I would appreciate any info.

Thanks in advance.

 

[Ron Olson]

On side exhaust engines I like the Traxxas header. It's tight against the engine and had a slight upward turn to clear radio boxes. If you have the rear (front) exhaust I think that I've used the Dynamite header.

Until Andy gets the AB 12 pipe out, most of us have been using the Mac pipe.

 

[MikeP]

This header has worked good for me.

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXBMF4&P=7

Mike

 

[Dan Chase]

Thanks, guys!

 

[raptor347]

Dan,

What are you building now?

Brian

P.S. I hope you're bringing the drag boats down the SAWs.

 

[Dan Chase]

Hi Brian,

Yup I'm bringing the Drag boats down to the LA SAW!

To answer your questions, this is what I'm working on. This one is a top fuel, it runs a .21, the top alcohol runs a .12 - .15 that I'm working on now. Notice we run boat pipes on them, so far most of the guys are running car pipes in the alcohol classes, just looking for an advantage!