What controls the side to side wobble at full speed?
This is the only problem that I needed to work on, Would the strut depth have any thing to go with it? I have set the hull on a flat surface and but an angle finder in the center section and set the hight of the strut till I made the front of the hull tilt down one degree with zero thrust change. So I ran the boat and had to reset the depth at the pond. and the hull runs with the same wobble and on the othe hand the water is still touching the back of the boat by three to four inches. Any ideas?
This is the only problem that I needed to work on, Would the strut depth have any thing to go with it? I have set the hull on a flat surface and but an angle finder in the center section and set the hight of the strut till I made the front of the hull tilt down one degree with zero thrust change. So I ran the boat and had to reset the depth at the pond. and the hull runs with the same wobble and on the othe hand the water is still touching the back of the boat by three to four inches. Any ideas?