Dustin Barbaglia
Active Member
- Joined
- Oct 9, 2011
- Messages
- 43
Here is what i have going on, on my mono i have three cooling lines, one in each rudder, and one pickup behind in the prop wash. My first thought was to run each one of these to a particular part of the motor, IE, upper water jacket, lower water jacket, exhaust header...... but i was thinking that if one port would get blocked, then one part of the motor would no get water. So i am considering taking all three lines in to a central block, and then branching off to the parts of the motor. this way if one piack up should become clogged, then ther other two would pick up the slack so to speak. Any thoughts of this, pros or cons ? Attach is a picture of my rear set up.