Radio box setup.

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Kyle Adams

Active Member
Joined
Jan 29, 2021
Messages
31
In a 1/4 scale tunnel hull I'll be installing a servo gearbox and haven't seen any good pictures of how radio boxes (hole through the top, I think) are setup to keep out water on this type of system. How is the arm attached to the gear? Is there an arm that is recommended? The gearbox and throttle mounts are easy enough to figure. Thank you all for your help.
 
Lawless sells the setup that is thru the top.

Steering Rod kit

My GX-480 is close to being completed. Going with a double servo setup with over 1100oz combined. Working out the details on how to setup the rods.
 
Lawless sells the setup that is thru the top.

Steering Rod kit

My GX-480 is close to being completed. Going with a double servo setup with over 1100oz combined. Working out the details on how to setup the rods.

Thank you for the response. I'm using the Lawless lower. Didn't look too see if they make linkage kits.
 

Latest posts

Back
Top