gooycheese
Chat Moderator
- Joined
- Nov 25, 2006
- Messages
- 1,801
Hi All,
I have a 7.5 Hawk, basically built right out of the box. On my Table I use either a .380 or .135 block for measuring AOA. On my front sponsons I know there is a slight arc to the bottoms will this cause my AOA measurements to be different ? I will slide a measuring block under the sponson until it touches the bottom of the sponson and then measure from that point to the trailing edge, this is how I get these numbers.
Here is an example: Block size @ Distance to TE
Right sponson:
.380 @ 5.812 = 3.579
.135 @ 2.718 = 2.764
Left sponson:
.380 @ 5.875 = 3.541
.135 @ 2.906 = 2.645
If anyone can figure this out Please Help.
Thank You,
Paul
I have a 7.5 Hawk, basically built right out of the box. On my Table I use either a .380 or .135 block for measuring AOA. On my front sponsons I know there is a slight arc to the bottoms will this cause my AOA measurements to be different ? I will slide a measuring block under the sponson until it touches the bottom of the sponson and then measure from that point to the trailing edge, this is how I get these numbers.
Here is an example: Block size @ Distance to TE
Right sponson:
.380 @ 5.812 = 3.579
.135 @ 2.718 = 2.764
Left sponson:
.380 @ 5.875 = 3.541
.135 @ 2.906 = 2.645
If anyone can figure this out Please Help.
Thank You,
Paul
Last edited by a moderator: