Mike lasorsa
Well-Known Member
- Joined
- Jul 19, 2022
- Messages
- 198
Got it used but have very little time on it. I have a thick o ring on the carb so I ordered the correct one to try and silicone the draw bar a bit. Mixture disc seals are newNever seen that spot leak enough to cause a problem. Is this a new issue, or have you always had it with this motor? Can you put a finger over the end of the draw bar on each side and effect the issue you are having? Those carbs are notorious for lean idle. Setting the mixture disc can be a pain.
Enter your email address to join: