Thanks, I haven't been over there in forever......I'lll go check it out.there's ongoin thread in the other web RCU titled Skater tunnel..
i used the TS2 radio box for the electronics.
jul
Hi IfergusonThanks, I haven't been over there in forever......I'lll go check it out.there's ongoin thread in the other web RCU titled Skater tunnel..
i used the TS2 radio box for the electronics.
jul
This is true James.. I should have mentioned that. I haven't checked this thread in a day or two, thanks for the help guys. This is going to be a FE setup. I need help with two things here. A) Servo install. I know were just not how. and B) The wires coming from the motor... I am thinking a plate about one or 2 inches long and run them through the plate.Guys, I am 95% sure that Lee is setting this up for FE, so it may be a little different than a nitro set-up.
If it were me, and I were building an FE boat out of the Skater, I would make the "radio box" the full length of the cut out from Ply, then section it into two sections so you have one compartment for all radio stuff, and one larger comparment for batteries. Have them separated with a bulkhead and sealed individually.
Heres a couple pics of mine, its an OLD boat, so its not pretty, but it works good...
Lee knows where the motor is!
~James
Don't know the speed a this moment, but I'm using some 60gram in the front.racej,what speed r u getting,,if ever u have?..any weights used?
Enter your email address to join: