hardware for 67 rigger

[taber]

I want to run a 67 rigger with square drive. Anybody have any suggestions for a decent hardware set up ? Also need some prop suggestions. Using pre exr picco p-67. ops 67 pipe, altitude about 700 ft above sea level , rigger is a cajun bullet .45/.67.

 

[ALLAN YUEN]

use speedmaster 40 hydro rudder assemly and Octura strut assembly with Solder flex ferrule brass for square cable drive. start use Octura 1460 Good Luck!

 

[Joe Warren]

use speedmaster 40 hydro rudder assemly and Octura strut assembly with Solder flex ferrule brass for square cable drive. start use Octura 1460 Good Luck!

A abc H30 or a octura 1662.

 

[Blackout]

Remember to use a thrust bearing between the strut and drive dog. Octura has them. I have a square drive Octura setup on my Skater .82 and it works good.