Flywheel puller Zenoah?

[WallyRC]

What are you using?

 

[Mark Anderson]

An aluminum bar with three holes in it. two outers are drilled through for 6mm bolts into the flywheel. center one is threaded for a push bolt. I have seen ones with just the 2 through drilled holes. by tightening the 6mm bolts, the bar just pushes on the end of the crank.

 

[Mike Hughes]

Everything you need to make it can be found at home depot.
Mike

 

[Daniel's Racing]

I make awesome little pullers. Easily pull a flywheel in 10 seconds every time.

 

[ChrisHerzog]

I make awesome little pullers. Easily pull a flywheel in 10 seconds every time.

Daniel, what is this for?

Also do you make a collet puller to get the collet off a Zenoah?

 

[John Seybold]

Thats used to install bearings in the Zenoah case. You put a bearing on each side, then slide warm case over. The tool ensures that the bearings are aligned when installed.

 

[ChrisHerzog]

Thats used to install bearings in the Zenoah case. You put a bearing on each side, then slide warm case over. The tool ensures that the bearings are aligned when installed.

Got ya, thanks.

 

[Daniel's Racing]

Daniel, what is this for?

Also do you make a collet puller to get the collet off a Zenoah?

Chris,
I do make collet pullers for Zipp and Speedmaster collets.

$34 shipped.