- Joined
- Aug 6, 2008
- Messages
- 121
To all engine builders. I would like to know what is the general rule of thumb regarding crankshaft runout and collet runout ? For high percision and maximum HP
anything over 0.0005 is NOT acceptable for optimum performance? Is this standard operating procedure? Does anybody make dead on collects? I appreciate it I could hear from Marty,Jack,Jim
Rod, Andy and Mark. Thanks for your help. Dan McCormick- NAMBA 221
anything over 0.0005 is NOT acceptable for optimum performance? Is this standard operating procedure? Does anybody make dead on collects? I appreciate it I could hear from Marty,Jack,Jim
Rod, Andy and Mark. Thanks for your help. Dan McCormick- NAMBA 221