CMD XT pipe

[Richard Dahlheimer]

Anyone have any feed back on this pipe, used for .21 rigger? Which motor etc. Thanks in advance. Richard D

 

[shoboat]

Richard,

If anyone has an extra, I would like to buy it and test it.

I would even trade a race ready propeller of your choice for one.

Thanks For Reading,

Mark Sholund

Props-4-U

 

[Buckshot]

Anyone have any feed back on this pipe, used for .21 rigger? Which motor etc. Thanks in advance. Richard D

I ran that pipe on my SGX-1 with a MAC .21 and it ran very well.

-Buck-

 

[Richard Dahlheimer]

Anyone have any feed back on this pipe, used for .21 rigger? Which motor etc. Thanks in advance. Richard D

I ran that pipe on my SGX-1 with a MAC .21 and it ran very well.

-Buck-

Thanks Buck. How did the XT pipe work, compared to the CMD fat pipe? Richard D

 

[ALLAN YUEN]

I did test run my CMB21 RS7 Valvola with cnc bullet xt pipe not bad because straight good fast and corner fair I like best one of Brown fat .21 pipe great super fast both straight and corner P.S the XT pipe was sold last year ago

If my CMB 21 worn out so will buy new A/A 21 engine through Al Hobbs in someday

 

[Richard Dahlheimer]

I did test run my CMB21 RS7 Valvola with cnc bullet xt pipe not bad because straight good fast and corner fair I like best one of Brown fat .21 pipe great super fast both straight and corner P.S the XT pipe was sold last year ago

If my CMB 21 worn out so will buy new A/A 21 engine through Al Hobbs in someday

Allan, thanks for your input. I had great results also with CMD fat pipe with old style Valvola. Could run fat pipe 7&3/8ths with 3.2 cup 1445. Richard D