Bob's GSX 310 from ML

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Well, I went ahead and did a new P limited RSX310 design today. Utilizing 1/16" ply vs 1/8" in several pieces of the kit. This should really help with weight. Also, I did this in a manor that should not hurt strength, so that was a positive. I will get this finalized and available soon! Mike
 
Also, the bulkhead behind the motor, is it o.k. to remove the top part? Will it lose too much torsion strength? I kinda had to cut it off to get my motor to mount up. Bad planning on my part :( My motor has very stiff leads (Scorpion) and after I built it I could not mount it otherwise.
 

Latest posts

Back
Top