All rattle can Zippkits G30 nitro tunnel!

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Bill Gibson

Well-Known Member
Supporting Member
Joined
Mar 7, 2007
Messages
3,790
I may regret this but i just did this G30 in Rustoleum orange and will do the orange cowl with Spraymax 2K clear after it dries for 5 or so days! The hull was sealed with finishing epoxy resin and then cleared with Spraymax 2K clear! Ive had better finishes, but i dont think that it looks too bad......either way its going to the Internats!!!!
 

Attachments

  • IMG_2612.JPG
    IMG_2612.JPG
    4.2 MB · Views: 0
  • IMG_2613.JPG
    IMG_2613.JPG
    5.2 MB · Views: 0
  • IMG_2614.JPG
    IMG_2614.JPG
    4.9 MB · Views: 0
The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.
 
The orange layed down nice.Looks good a little orange peal don’t hurt some new cars have that effect.
Thanks Bruce! After a week im going to wet sand the cowl and clear it! Canned finishes dont give the finish that 2 part automotive finishes give, but it was nice to just shake up a couple of cans and shoot! And im pretty happy with the results!
 
I may regret this but i just did this G30 in Rustoleum orange and will do the orange cowl with Spraymax 2K clear after it dries for 5 or so days! The hull was sealed with finishing epoxy resin and then cleared with Spraymax 2K clear! Ive had better finishes, but i dont think that it looks too bad......either way its going to the Internats!!!!
Could you post a picture of how your internals are setup? I'm currently building a G30 with same outboard and trying to figure out. Thank you.
 
Back
Top