Buddy Lowe
Well-Known Member
- Joined
- Oct 18, 2007
- Messages
- 152
Needing measurement for strut depth. Strut is on back of transom???
40 whip
- Thread starter Buddy Lowe
- Start date
Help Support Intlwaters:
- Joined
- Oct 13, 2004
- Messages
- 1,777
Hey Buddy,
Since most Sport 40 boats are probably set up close to the same thing, My MLBoatworks GP400 runs well with the bottom of the strut set at the same depth as the depth of the rear of the sponsons. The bottom of the strut is even with the bottom of the boat..... no angle. You may need to tweek on this for your particular boat. With the balance point about 1 inch behind the rear of the sponsons this should get you going in the right direction..
Dick Tyndall
Since most Sport 40 boats are probably set up close to the same thing, My MLBoatworks GP400 runs well with the bottom of the strut set at the same depth as the depth of the rear of the sponsons. The bottom of the strut is even with the bottom of the boat..... no angle. You may need to tweek on this for your particular boat. With the balance point about 1 inch behind the rear of the sponsons this should get you going in the right direction..
Dick Tyndall
Last edited by a moderator:
