The turn fin is swept back and I now have it about 3/4 inch below the keel. The wood I added to the chine is 1/8, not 3/16. If I fill in the pad with bondo my prop will be about 1/2 in above the keel so that is not an option. Thanks for he info guys.
I have a Youngblood mono with the COG set at 33%. I've tried the turn fin at 1 1/2 and 2 inches below the bottom. The right trim tab is set to just touch a straight edge laid on the bottom. The left is set 1/32 above the straight edge. The turn fin seems to lift the right side out of the boat...
I liked the ease of adjusting a stinger so I cut it down to the length of the strut that was on it originally.I removed the built in trim tabs and installed these. This boat has the delta pad on the bottom.I also modded the hull by adding a 3/16 wood strip along the bottom edge of the boat. I...
I just dusted off my 38 in Youngblood mono and it's running pretty well. It has a mildly modded 65 CMB silver head in it. I replaced the strut with a cut down Speedmaster stinger. It is the hull with the delta pad and built in trim tabs. I replaced the tabs with Speedmaster tabs. I clocked it at...
Glad to hear you made it safe. I'm dusting off all my nitro boats and it is nice to know I don't have to worry about my fuel tanks because they are all your tanks. Thanks for making a great product. They also look a lot sexier than a plastic tank. Jim
I have the boat sitting on my setup board and was wondering how deep the strut should be. Should the bottom of the boat be level with the setup board? Also, what angle should the bottom of the strut be? Should it also be level? I appreciate any help you guys can give me. Dusting her off after a...