Search results

I was wondering if anyone had a CMB 101 RS with a pipe hanging around. Thanks, Jim Fullmer

The turn fin is swept back and I now have it about 3/4 inch below the keel. The wood I added to the chine is 1/8, not 3/16. If I fill in the pad with bondo my prop will be about 1/2 in above the keel so that is not an option. Thanks for he info guys.

Never tried it without the fin.

Here ya go. The turn fin is 90* to the bottom and extends down where the side meets he bottom (if that's what you are wondering).

I have a Youngblood mono with the COG set at 33%. I've tried the turn fin at 1 1/2 and 2 inches below the bottom. The right trim tab is set to just touch a straight edge laid on the bottom. The left is set 1/32 above the straight edge. The turn fin seems to lift the right side out of the boat...

Yes and while I was at it I blueprinted the bottom.

A friend of mine had a stock OPS 45 and that thing screamed.

I liked the ease of adjusting a stinger so I cut it down to the length of the strut that was on it originally.I removed the built in trim tabs and installed these. This boat has the delta pad on the bottom.I also modded the hull by adding a 3/16 wood strip along the bottom edge of the boat. I...

I found an X457 in my box. How much for the X455 Mike?

I need an X455/3 blade and an X457/3 blade prop. I have plenty nitro and gas props to trade.

I just dusted off my 38 in Youngblood mono and it's running pretty well. It has a mildly modded 65 CMB silver head in it. I replaced the strut with a cut down Speedmaster stinger. It is the hull with the delta pad and built in trim tabs. I replaced the tabs with Speedmaster tabs. I clocked it at...

Glad to hear you made it safe. I'm dusting off all my nitro boats and it is nice to know I don't have to worry about my fuel tanks because they are all your tanks. Thanks for making a great product. They also look a lot sexier than a plastic tank. Jim

Sounds OK. Pm me your info.

How much is shipping to 70005 for the # new servos. I'll take them.

I have the boat sitting on my setup board and was wondering how deep the strut should be. Should the bottom of the boat be level with the setup board? Also, what angle should the bottom of the strut be? Should it also be level? I appreciate any help you guys can give me. Dusting her off after a...

I'll pass Jeff. That's not the pipe I was looking for. Thanks anyway.

I'm interested in the header and pipe pending pics.

You could post a pic here if it would be easier.

Did not get them

I'll take it pending pictures. I'll pm my address