Recent content by Terry Heddin

1/8 ply with 1/8 balsa laminated to either side. Built with a tab on the bottom of ply keyed into a slot on turtle deck.

Zenoah stock 32 vs Redline Pro Mod 29 https://redlinemotors.us/products/ols/products/zenoah-moified-engine-30cc-znh-mfd-ngn-30c1 Which engine would likely have the most power?

What is a "hot pipe" vs just a tuned pipe?

Are there any onboard remote starters available, that are dependable, or is that "pie in the sky"? Thinking it would be a nice addition to my 5 1/2ft hydroplane.

That's about what I was thinking. Hoping for other thoughts as well.

I have a 48" hydro and a 68" hydro in the works. Looking for the best way to retrieve when they don't make it back to shore. I have an inflatable pontoon to go after them but not sur about lifting them on the pontoon. Any input?

I have found, that when it does go bad, will leave a dark ring in the jug, around the surface level.

I have the of engine side of the cooling flange. I was just curious about the collar. I looked it up on Hanson's site. All the info was there.

What type of pipe is this header set-up for?

Defiantly planning to get a rope or pole with a hook, or something similar. I found out about trying to put a big boat in the retrieval boat last week. Swamped my 12ft flatbottom while trying to lift my Zippkits SLR Missile into the boat. I plane to test it before paint, so I can change whatever...

Yes, dual pick-up. It's 36" from the water pick-ups on the rudder, so I want to make sure it gets enough water.

Thanks, that's what I suspected on the head, but did know if it made a difference on the manifold.

Should the water enter the head from the top, or the bottom? What about the manifold flange, enter from top, or bottom?

Making a little progress on my 68" Atlas Van Lines, Blue Blaster.

Thanks. That makes sense.