Starting to plan a paint job on an outrigger. Have used spray gun/ compressor set-ups with
PPG Deltron base coat/clear coat years back, but don't want to get into all of that hassle and
health hazard stuff now.
Hydro will be sealed with finishing resin, and we'll block it down good and set up finish quality
with a primer/surfacer.
Want to use aerosol cans. We really like that Duplicolor ceramic engine paint and have had
very good results with it on Lawn Boy lawnmowers. Just important to follow the flash time
intervals and temp recommendations. Stuff levels great. Gasoline, Klotz, Seafoam have no
effect on it once completely dry.
Would let the stuff dry well, making sure the solvents gas out good before clearing.
I guess my question, or questions, are- does anyone know if that ceramic engine paint is
methanol/nitro proof, and can I prep the finish surface and apply 2K Glamour Hi Gloss 2 part
clear over it, and graphics, leaving a methanol/ nitro proof finish?....
Not sure if we'll be air brushing or making stick on graphics with thin, clear glossy vinyl/ polyester
Any direction and guidance would be greatly appreciated. Thanks!