Thanks Greg, I will post more pictures and info after a run. Wieght now with 400g in an IV bag in the nose is 9.2Kg and CG at 15" .Hey Winston
Awsome job mate
thats a good looking F1 Tunnel
Greg
No Problema, Buddy it`s no secret,Hi Winston,
Thank you for sending me all of the pictures! I am going to be using a gmorty on mine as well. The pictures of everything inside the cowling are amazing as well!
Haydon
Hey Winston
Awsome job mate
thats a good looking F1 Tunnel
Greg
Who made the pipe?No Problema, Buddy it`s no secret,Hi Winston,
Thank you for sending me all of the pictures! I am going to be using a gmorty on mine as well. The pictures of everything inside the cowling are amazing as well!
Haydon
Hey Winston
Awsome job mate
thats a good looking F1 Tunnel
Greg
~~~`Winston`~~~
Markjor, The CG is measured from the end top of the sponsons and it should be 15" if when you build the Hull complete and it's not 15" than you have to put an IV bag with water in the nose of the Tunnel to increase more weight at the front end of the boat, in mine OSSI I had to put 400 ML of water. I run the boat with a standard engine to see how the boat Handel just before I paint it than after I made lots of modification to reduce the weight especially from the rear side of the Hull. Go to youtube and see my Tunnels running. http://www.youtube.com/watch?v=IP4KqZbhOg4Hi, how long is the boat and where do you measure your cg from , the transom or the back of the sponson , have you run the boat yet
hope it all goes well
Hello Peter, Thanks, Do not forget to send me them DECALS you promesd.Hello Winston,
Your boat is super. It looks just chick. Respect!
Regards Peter
I tried last Sunday but someone put boat barriers so there wasn't room for speed, the cornering is brilliant anyway so I have to try this weekend again,Have you had a chance to run and video the boat yet , if so how did it go
I have to go to my workshop and tell you tomorow, it`s a very good paint and it is very high tempreture.Very clean... and It even looks fast! What coating Is that on the pipe?
D
This is the exhaust paint, PLASTI-KOTE LTD, PO BOX 867,Very clean... and It even looks fast! What coating Is that on the pipe?
D
Enter your email address to join: