winzracing
Well-Known Member
- Joined
- Dec 26, 2007
- Messages
- 65
Hi guys , I have a 3.5 OS POWEREHEAD and i want to adapt fit it too a KB lower unit . the KB lower has been modified to run the pipe . is there a adaptor the OS fits onto ??? cheers
I'll secon that I remember reading about that lower unit test. There is also a very good propshaft assemble you can buy, help me out someone. Forgot where to get it (I'm getting old).and kris flynn can make flex's to fit, just give him the length you need. btw, someone, maybe rod g. , ran a dyno test on available lowers. k&b registered the lowest frictional driveline loss.........os, lawless, rek, bullet drive, you name it.
I believe Big Bryon had some prop shafts if I remember right.I'll secon that I remember reading about that lower unit test. There is also a very good propshaft assemble you can buy, help me out someone. Forgot where to get it (I'm getting old).and kris flynn can make flex's to fit, just give him the length you need. btw, someone, maybe rod g. , ran a dyno test on available lowers. k&b registered the lowest frictional driveline loss.........os, lawless, rek, bullet drive, you name it.
I'll secon that I remember reading about that lower unit test. There is also a very good propshaft assemble you can buy, help me out someone. Forgot where to get it (I'm getting old).and kris flynn can make flex's to fit, just give him the length you need. btw, someone, maybe rod g. , ran a dyno test on available lowers. k&b registered the lowest frictional driveline loss.........os, lawless, rek, bullet drive, you name it.
Enter your email address to join: