WTB picco. 67 crank bearings

[Davidrichmond]

Looking for two sets of crank bearings for the picco .67 two piece case engine.
Engine shown in photo, thank you.

According to the engine builder they aren't 6001 or the 608's.

 

[Mike Hughes]

These are the bearing I ran years ago in my Picco 67 EXR Round Bottom sm 608, lg 16002 Your pic is the round bottom. Not sure why he says no 608.
If you had the square botom case then it would be Picco 67/80 EXR Square Bottom sm 6901, lg 16002
Mike

 

[Davidrichmond]

Thank you Mike, I will pass the information to him.

These are the bearing I ran years ago in my Picco 67 EXR Round Bottom sm 608, lg 16002 Your pic is the round bottom. Not sure why he says no 608.
If you had the square botom case then it would be Picco 67/80 EXR Square Bottom sm 6901, lg 16002
Mike

 

[happybradboating]

Try BOCA Bearings. I have obtained anything ever needed from them in the past for nitro motors. Brad

 

[Mike Betke]

The round bottom case can have either the 608 or 6901 bearing in the front. Just measure the diameter of the crank and compare it to the ID of the bearing. The 16002 bearing is common for the big rear bearing.

Try Jon Thibodeau (tnrcboatracer) on here. He was selling the good WIB bearings for those motors.

 

[Davidrichmond]

Thank you everyone for your replies. We ordered some 6901's from BOCA.
Thanks again.

 

[Mike Hughes]

The round bottom case can have either the 608 or 6901 bearing in the front.

Well aint that special.....LOL Learn something new everyday. Thanks Mike