anthony_marquart
Well-Known Member
- Joined
- Nov 4, 2003
- Messages
- 3,744
Bump!!! Is this a dumb question or did I not explain it well?
I have been looking at different versions of teardrop mods to piston sleeves. These cuts are usually on one end of the port, the end nest to the exhaust port.
Why is the slot only at one side of the port? Wht would be the result if the cut was take from one side of the port all the way to the other?
I have been looking at different versions of teardrop mods to piston sleeves. These cuts are usually on one end of the port, the end nest to the exhaust port.
Why is the slot only at one side of the port? Wht would be the result if the cut was take from one side of the port all the way to the other?
Last edited by a moderator: