J
just for fun
Guest
I've been given two OPS .60. The conrod has spun the bush in the big end. I have access to lathes mills etc. I am looking at building a new rod. What alloy would be best to make to make a new rod from?
I may have a Good rod But i would need you to ship me one......... are these rods bushed on both ends? jwI've been given two OPS .60. The conrod has spun the bush in the big end. I have access to lathes mills etc. I am looking at building a new rod. What alloy would be best to make to make a new rod from?
7075I've been given two OPS .60. The conrod has spun the bush in the big end. I have access to lathes mills etc. I am looking at building a new rod. What alloy would be best to make to make a new rod from?
Phil send me the rod, if I have one you can have it? I`ll send it back to you. Joe Warren 775 Crimson oaks Lane Collierville TN 38017Thank You Joe W, The rod I have is ok apart from the bush has spun.
Thank You also Jack, Thats the info I was after. Was talking to a friend of Dave Richardson's and he said Dave used same material. All Good thanks once again.
Phil
too bad Dave Richardson (RPM) is not making rod's anymoreWas talking to a friend of Dave Richardson's and he said Dave used same material
Enter your email address to join: