NovaRossi .67 Bolt Pattern?

Discussion in 'Outboard Forum' started by jaxracer, Jun 14, 2019.

intlwaters.com

Help Support intlwaters.com:

  1. Jun 14, 2019 #1

    jaxracer

    jaxracer

    jaxracer

    Well-Known Member

    Joined:
    Jan 17, 2005
    Messages:
    601
    Location:
    Jacksonville, FL
    A pretty general question but what lowers are you guys running with these? I’m assuming it fits the K&B .67 lower bolt pattern?

    Thanks!
    -Mitch Jr.
     
  2. Jun 14, 2019 #2

    MarkScott

    MarkScott

    MarkScott

    Well-Known Member

    Joined:
    Oct 6, 2014
    Messages:
    2,861
    yes, the NR .67 will use the 11CC bolt pattern. Just drill out the hole to allow the 4mm bolt to pass thru. The center hole, the flex shaft, may need to be enlarged also as the C clip may interfere. At least it does when using the Lawless lower. I've never put my NR .67 on a K&B lower.
     
  3. Jun 14, 2019 #3

    MarkScott

    MarkScott

    MarkScott

    Well-Known Member

    Joined:
    Oct 6, 2014
    Messages:
    2,861
    Mitch, sorry, had to go back and look at my emails to Fred Howe on the lawless. The NR .67 lines up with the K&B 7.5 mount, not the 11cc. Still need to drill the holes out to allow a 4mm screw to pass thru.
     
  4. Jun 14, 2019 #4

    topfuel443

    topfuel443

    topfuel443

    Moderator Moderator

    Joined:
    Oct 23, 2002
    Messages:
    6,005
    Location:
    Atlanta, Georgia
    11cc lower and 7.5 cc lower are the same bolt pattern, its just that the 11 cc is already drilled out. The 7.5 is threaded, and you will have to drill it out like Mark mentioned.
     
  5. Jun 14, 2019 #5

    MarkScott

    MarkScott

    MarkScott

    Well-Known Member

    Joined:
    Oct 6, 2014
    Messages:
    2,861
    My experience is only with the Lawless lowers. The 11cc plate I have was different than the 7.5. Think it didn't have enough meat on the outer edge. Thanks for the clarification Gabe.
     

Share This Page



arrow_white