Mt backlash build

[RobertWurster]

Well finally got going on this.Lots of work done and lots to do.Thanks for looking.Robert

 

[Samuel Hagan JR]

How hard is it to assemble? I'm seriously thinking getting one for the winter.

 

[RobertWurster]

Its not to hard but the sponson sheeting is not to eazy with the complex curves of the front .Just make sure you keep it flat and square when glue and read the instuctions a lot ,A good flat build board lots of clamp and sand paper .If you have a 4.6 inch belt sander it helps a lot. Just take your time and plan every thing and you will be ok.

 

[RobertWurster]

Got more done sponsons are done now to get back to work,

 

[Lay26]

i see this kit went through some changes on the sponsons the first few didn't have a step at the back... whats the dept of the shingle at the back of the sponson?

 

[RobertWurster]

The rear sponson is 7/8 from the bottom of the boat.

 

[RobertWurster]

Well getting there .I love sanding.

 

[John Christy]

If I may where are you planning on putting the fuel tank and are you using a hard tank or an IV

Thank you

Ron

 

[RobertWurster]

Iv bag 250 ml in the nose Ive been real buzzy but ill post picks as soon as I can.

 

[RobertWurster]

Here is some up dates new engine Rev unlimited 26 cc full race mod with full race mod 257 carb .The hole in the front is where the Iv bag is going. I have also dowled it in critical spots

 

[John Christy]

You think a 250 IV will be enough fuel ?

Thanks for getting back to me

Ron