misc. stuff and engine

[camaroboy383]

1) .187 flex shaft with 3/16" stub stepped to 1/8" the flex alone is about 3ft long,,not including the stub...several shafts here if you cut it up...

$15.00 shipped

2) sullivan stainless steel 12" threaded rod... new in package 2 pieces of 12" rod included in the package...

$5.00 shipped

3) macs .12-.18 side exhaust header,, been cut back about an inch,, mounted but never run...

$8.00 shipped

4) 17" aquacraft starter belt,,, new in package...

$7 shipped (sold)

5) GO marine .25 rear exhaust 3 port natural case engine... new never fired and has a belt start back plate installed... no flywheel or collet...

$90.00 shipped (sold)

6) GO marine rear exhaust .18 engine... pile of parts,,, good usable engine,,, but needs a set of bearings... engine is apart...

$35.00 shipped...

7) 3M radio box tape from tim jones,,,,

$10.00 shipped...(SOLD)

post here if intersted in anything,,, paypal to [email protected]

thanks,,Alden

 

[mike stover]

Alden

I will take the radio box tape.

Mike

 

[camaroboy383]

its yours mike...... how you been buddy???? shoot me a pm with your addy...

alden

 

[Rene Danner]

I will take motor and belt.Thanks

 

[camaroboy383]

rene,,, they are yours brother... i know ive talked to you since this post,,,but whatever...... :lol: .......... much easier to talk on the phone aint it..... :lol:

 

[Rene Danner]

Yes it is,Thanks Buddy..

 

[Mike Stuchell]

PM Sent concerning the Macs header

Mike S.