Aidan Nicholas
Member
- Joined
- Jan 30, 2009
- Messages
- 11
Last edited by a moderator:
Nice looking boat. Welcome to IW.Yo all, I'm new to this forum. Been on RCU a few years though so some here will probarbly know me from there. My current project is a .21 Speedmaster Mono. Jsut starting to get towards the finishing stages... Turning out to be quite an expensive boat to build.... Here are some pics.
Because the prop will be too far from the transom without cutting the stinger. I have the same boat and stinger and it handles worlds different (read: bad) without cutting the stinger back 1/2 inch. Remember, hardware is not one size fits all, merely a starting point for where you are going.I already have Speedmaster mounts for the motor.... Take 1/2" off a beautifully machined $40 Strut? why lol.
Jim. The hull is ready made and ready to go into the water.. The tube will exit straight through the transom. or so ive been told which is where ive drilled the hole..
Thanks for the help and advice guys. i appreciate it
Aidan
Enter your email address to join: